Solutions To The Failure Of Laser Light Output From Co2 Laser Machine.

As the machine is running, the laser light unexpectedly vanishes.

A: To verify whether an alarm signal has been sent by the water chiller, please provide a method that would rearrange the given content and ensure that the generated content is closely related to the original text information.

b: In the event of an alarm signal, it is advisable to connect the Output and Inlet through a single pipe and then observe if the alarm signal persists. If the signal reappears, it indicates potential problems with the water chiller. Conversely, if the signal disappears, it suggests that there might be an obstruction hindering the water flow. In such a scenario, it is crucial to inspect the water pipe for any bends or pressure exerted on it. Additionally, it is essential to ascertain if there are any debris present in the water and promptly replace it with purified water if necessary.

b：In case there is no alarm signal, it is worthwhile to check if the power supplier fan is spinning. If you see the fan whirling, then some power is being supplied to the device.

To link up the laser power supply, we need to connect the electric line. Can you help me with this task?

There are several things to check if the laser tube does not produce light. First, it's important to see if there is actually laser light inside the tube. If there is light, then the problem might be with the control card, which could have some loose lines, or it might have broken down entirely and require replacement.

If there is no light in the laser tube, it's more likely that the power supplier has broken. However, this is not always the case, as there is a low possibility of the laser tube breaking. To determine the cause, it's important to check if there are any splashing sparks at the high voltage side of the laser tube. These sparks can potentially burn out the power supplier and control card parts.

If the power supplier fan is not working, then it's important to test the 220V port on the supplier with a test pencil. If the test pencil shows electric signals, then the power supplier has broken and needs to be replaced. If there are no electric signals, then the supplier switch and electric lines need to be checked.

Overall, there are a few possible causes for a malfunctioning laser tube, but with proper diagnosis and troubleshooting, the issue can be resolved.

2. If the operator is not familiar with the operation of the machine and there is no laser light appearing after starting it up, it's important to check several aspects to troubleshoot the problem. Make sure to thoroughly inspect the machine and its components to try and identify any issues. It's important to take a logical and systematic approach to identify any potential problems and work towards a resolution. Remember, safety should always be a top priority when working with machinery.

a. To verify the status of the laser power supply switch, we need to determine if it is in the on or off position. Let's inspect the switch to ensure its current state.

b. Checking the water chiller is opened.

c. To verify the accuracy of the control board, we should examine if the processing power has been correctly set and whether the computer software meets the specified requirements.

d. 要检查光路是否调整良好，可以观察激光管内是否有激光光线，如果激光头没有发出光线，则激光路径可能存在问题。